How do you tighten the chain on a razor mx350?
Slide the axle into the slots on the frame. Slide the chain tensioner down and maneuver the chain onto the sprocket on the rear wheel and motor. thread the cable wire into the cable anchor. Thread the cable to its original position and tighten securely.
How do you change the chain tensioner on a Razor e300?
(1) Using a Philips screw driver remove the 3 screws on the chain guard and remove the chain guard. (2) With a flat screw driver remove the spring from the tensioner arm. (3) Using 2 size 10mm open wrenches loosen up the nut and bolt that holds the tensioner onto the frame and remove it.
How do you align a Razor scooter?
Using your hand, carefully turn the upper headset crown counterclockwise 1/4” at a time until handlebars turn smoothly. Test after each 1/4” turn. Note: Make sure the handlebars are properly aligned with the front wheel before riding.
How do you fix a razor?
Here are some tips for razor burn relief.
- Aloe vera. Aloe vera is known for soothing and healing burns.
- Coconut oil. Coconut oil is used in cooking, but it’s also great for your skin.
- Sweet almond oil.
- Tea tree oil.
- Witch hazel.
- Baking soda paste.
- Cold and warm compresses.
- Colloidal oatmeal bath.
What version is my razor mx350?
The version number is located on the ID tag which can be found on the the bottom of the scooter, or on the steering tube. Below is an example of what the ID tag will look like. The 7th and 8th numbers on the ID tag are the version number of the scooter.
How do you clean a razor mx350?
How do you wash the mx350? Do not wash with water. Just use wet cloth.
How do you charge a razor Power Rider Xbox 360?
Your PowerRider 360 may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. charger port on the product. Make sure the power switch is in the OFF position. The light on the charger should turn red during charging.