- 1 Can I ride my motorcycle with a loose chain?
- 2 Why does my motorcycle chain have a tight spot?
- 3 How do I know if my motorcycle chain needs Lube?
- 4 What can happen if your motorcycle chain is too loose?
- 5 Can I ride with a loose chain?
- 6 How often do motorcycle chains break?
- 7 What causes uneven chain tension?
- 8 Can I use wd40 on my motorcycle chain?
- 9 What is the best lubricant for motorcycle chain?
- 10 Should I lube a new motorcycle chain?
Can I ride my motorcycle with a loose chain?
Yes it can be a little more messing around rolling the bike around to see if there is a tight spot or not in the chain, but it can still be done. Most bikes you can get the rear wheel off the ground by propping up the swingarm on the RHS and supporting the bike there, plus on the side stand and front wheel.
Why does my motorcycle chain have a tight spot?
It can be because of a poor quality chain stretching unevenly, an old chain in need of replacement, a rear sprocket spinning out of round, the rear wheel not being square inside the swingarm or even a slightly bent otput shaft. Tight spots where chain is starting to bind.
How do I know if my motorcycle chain needs Lube?
You should always lube /clean your chain if it looks dry or rusty, OR if it’s become a gooey oily mess. How To Clean Your Motorcycle Chain
- Use a brush and kerosene to use solvent to remove excess grime.
- Get the rear wheel off the ground so you can spin the tire freely.
- Make sure to let it dry COMPLETELY before lubing it.
What can happen if your motorcycle chain is too loose?
* Chances of breaking the chain is very high, which might result in a harm for other parts of the motorcycle and the rider as well. * Reduced suspension travel due to the high amount of tension. * Power loss due to higher friction (though the amount is negligible).
Can I ride with a loose chain?
Just be very smooth with the throttle no sharp acceleration or changes in speed and you should be okay*. Have a look at quite how loose it is before going, if its really loose then you’ll need to be more careful when riding but as long as the chain is still one piece then you can ride just being appropriately careful.
How often do motorcycle chains break?
But chains wear out over time and need replacing. So, how often should a motorcycle chain be replaced? In general, a properly maintained motorcycle can will last 20,000 to 30,000 miles, sometimes more. But, some last as little as 5,000 to 10,000 miles.
What causes uneven chain tension?
The most likely reason is either that the chain is low quality or you’re keeping it too tight. It’s always better for a chain to be a bit on the loose side than even the tiniest bit too tight.
Can I use wd40 on my motorcycle chain?
So, can I use WD-40 on my motorcycle chain? It is highly recommended that you do not use Multi-Purpose WD-40 on your motorcycle chain. The WD stands for Water Displacement, and it is designed to disperse water away from metal parts to prevent rust.
What is the best lubricant for motorcycle chain?
The Top 3 Chain Lubes
- Motul C5 Chain Paste. For over 150 years Motul has produced premium oil and lubricants.
- WD-40 Motorcycle Chain Lube. WD-40 Specialist Motorcycle Chain Lube, like all their products,is an easy to apply synthetic formula.
- Motorex Racing Chain Lube.
Should I lube a new motorcycle chain?
The factory lubricant all by itself is usually good for several hundred miles of service if the bike is not ridden in wet or dusty conditions. It is best not to apply any sort of lube to a new chain until it is clearly needed, because any wet lube you can apply will dilute the factory lube.